S&W BodyGuard 380

Installing a "RTK Edge SK trigger"

Ruger

Kel-tec

Taurus

How to install

 

 

Links

 

 

 

 

 

 

 

 

 

Unload your Bodyguard Field Strip
a a
Drive out two steel roll pins with 3/32" punch. a
Roll pins removed.

k
Frame removed.

NOTE: "U" Spring above trigger pivot has a mind of it's own, and will fly.

Figure 20-30 minutes to locate...
l
  l
Test fit pivot into Edge trigger

Stainless steel set screw.
Uses 0.050 allen wrench
l
Install trigger and pivot into frame.
Tighten Stainless steel setscrew to secure pivot in trigger.

Install linkbar. wind pivot spring counter clockwise.

l
Using your index finger to hold the linkbar in place on the right side of the frame.

Place the slide lock in place.
Use your thumb to firmly hold the "U" Shaped spring in position.
k
Slide the hammer spring onto the post.
Now slide frame into stock. Maintain finger pressure on frame.
a
Lay safety on side of frame.

Push frame completely into stock.
Insert roll pins.

Replace slide.
j
You are not done yet...
Please refer to
 
Adjusting your "RTK" trigger

Please note: There is only "1" reset click on the Bodyguard !
k

 
Adjusting your "RTK" trigger

FIREARMS SAFETY IS YOUR RESPONSIBILITY

Safety must be the first and continual consideration of every person who handles firearms. Read the owner’s manual and treat every firearm with respect.

RTK Strategic LLC provides quality U.S. made products for intelligent, responsible firearms owners. It is the buyer’s responsibility to be absolutely certain that all parts are correctly fitted and installed.  The buyer and installer of parts must accept full responsibility for the correct adjustment and functioning of the pistol after such installation. 

Altering any product on the market comes with risks, so please understand and accept that we assume no liability for injury to the buyer or anyone residing with or operating with the buyer. The buyer is the sole responsible party for the use of their firearm with or without our parts.